Yugo 1.5mm Blank (US Stamping) NON FFL

Childers Guns - Yugo Blank

This Blank will fit all 1.5mm Yugo kits  (M70, M72, RPK, Underfolders) (NOTE: both M70AB1 and NPAP kits use a 1mm receiver instead)
(The back of the receiver is slant cut to fit Yugo parts kits)

All holes are machined using CNC to insure accuracy.

• Fully heat treated to 40 HRC
• Lower Rails Spot welded
• Top Rails Trimmed to Spec
• Mag Stabilizers Trimmed to Spec
• Center Support Installed
• Trigger Guard Rivet holes drilled

Fixed stock trunnion holes are pilot holes only (.125"), they must be enlarged/fitted to your trunnions.

This 80% blank for sale is for a Yugoslavian 1.5mm kit.

U.S. Sec 922r compliant part.

Each receiver is custom made, see availability for delivery times.

For all underfolders and sidefolders the cuts will be without trunnion rivet holes unless you select the option – Rear Trunnion Rivet Holes. This will allow the builder to better fit the rivets.

This Blank requires no FFL.

We also have Layout Guides, see related products below.

Where to purchase AK Kits - CG AK Resources listing vendors that sell AK / AKM kits

Who will Assemble AK Kits - CG AK Resources listing gunsmiths and manufactures specialing in AK / AKM

Engraving Gallery - For Emblem Engraving Examples

Cletus Yeetus on 11/02/2020

Absolutely top notch receiver blank. Heat treat is on point, trunnions fit without issue, and the engraving was very well done. Ejector needed a little trimming to allow the bolt to ride over it, but that's an easy fix with a file and most likely intentional, as it's easier to take metal off of the ejector than to put it back on!I'm not sure what finish was applied to these, or if it's just left over residue baked into the surface from heat treat, either way I plan to strip it and blue it myself to match the kit. Very happy with my purchase!

Dan on 11/12/2019

I was very pleasantly surprised at the quality and precision of this receiver. The rails were installed perfectly, the center support looks professionally done, the Trunnions from my de-milled kit fit like a glove and Childers even had the foresight to cut the sling groove in the LH side and drill the third rivet hole for the pistol grip nut (which also aligned with my rear trunnion!). I was also able to use Childers' plastic layout guide to drill the FCG, which worked perfectly as well.I am extremely happy with this purchase and will 100% buy receivers from Childers again.

Drexel on 02/17/2018

I used this blank for my yugo m72 Rpk build and went together great. The bends, magazine opening, engraving, and well pretty much everything about it is top notch. Thanks childers guns for a top notch product.

Showing 1 to 3 of 3 (1 Pages)

Write a review